Post by granlund on Jun 21, 2008 3:05:32 GMT 7
A debian install on my n2100 did not go completely as planned... essentially I have no contact with the machine.
I started out with FW 2.01.09 with SSH and telnet access. The LAN1 port has been broken since a long while so it was running with 192.168.2.100 on LAN2.
After following these instructions, I lost contact with the machine. It apparently boots up to the blinking orange light according to the instructions, but I cannot contact it.
At the bottom of this page, it states that FW 2.1.06 changes the default IP to 172.16.66.51 on eth0, but is it the same on FW 2.01.09? And what is it on eth1?
I started out with FW 2.01.09 with SSH and telnet access. The LAN1 port has been broken since a long while so it was running with 192.168.2.100 on LAN2.
After following these instructions, I lost contact with the machine. It apparently boots up to the blinking orange light according to the instructions, but I cannot contact it.
At the bottom of this page, it states that FW 2.1.06 changes the default IP to 172.16.66.51 on eth0, but is it the same on FW 2.01.09? And what is it on eth1?