|
Post by oatmeal on Dec 11, 2008 21:22:44 GMT 7
Dear all,
After installing and activating the SSH 4.1.00 module on my N2100 I can't access the web interface anymore. I performed a harware reset. I can successfully ping it with IP 192.168.1.100 but entering this IP into the web browser doesn't work.
Is there a way to flash the device with the actual firmware again? I had firmware v2.01.10 installed. Or is there anoter solution to reanimate the NAS?
I would much appreciate not having to throw my NAS away!
Thanks!
|
|
|
Post by transparentopacity on Dec 23, 2008 16:53:11 GMT 7
Make sure you're going to https:// - sometimes going to the IP directly doesn't forward you through. I had this problem too.
|
|