Post by hybrid on Jul 21, 2008 19:05:32 GMT 7
i've setup the ftp in the thecus control panel on, using port 4466. I've forwarded that port in my netgear router to 192.168.0.100 which is the ip of 4100+.
When I ftp locally to 192.168.0.100 command line or any ftp client, it works perfectly.
But when I try to ftp from outside, I run into problems:
(same issue command line or client)
It connects fine, it authenticates fine. I can change directory fine. And it tells me if I tried to change to directory that does not exist. but directory listing does not work!
when I do 'ls' command (this works if I do it locally), it gives me 200 Port command successfull and then after a while gives me 425 no route to host error.
I've tried active and passive mode and extended passive mode with no luck, apart from active doesn't seem to work even this well.
Any help appreciated.
When I ftp locally to 192.168.0.100 command line or any ftp client, it works perfectly.
But when I try to ftp from outside, I run into problems:
(same issue command line or client)
It connects fine, it authenticates fine. I can change directory fine. And it tells me if I tried to change to directory that does not exist. but directory listing does not work!
when I do 'ls' command (this works if I do it locally), it gives me 200 Port command successfull and then after a while gives me 425 no route to host error.
I've tried active and passive mode and extended passive mode with no luck, apart from active doesn't seem to work even this well.
Any help appreciated.
