|
Post by changlinn on Mar 1, 2007 13:50:24 GMT 7
Ok got one of these to try out at work. Got the box, put in two 500gb samsungs, and started building a raid1 array. While it was doing this, created users, groups and folders, gave permissions to groups to folders, this did something odd though after saying succesful it went back to the acl page with no groups/users in any column, but this didn't work, it just keeps asking for user/pass, with public access enabled it works, but not what I want. Waited for the array to finish building in case that was the cause of the issue, tried again, no good, recreated, users and shares, re-set acls, still no go. Tried turning off jumbo frames, and changing the domain back to blah.local from works domain. Unit needed reboot, on reboot, array was broken, kicked off rebuild. Have also tried the reset button on the back no go. And at one stage tried installing the ssh mod which goes to a blank page and doesn't do anything.
Firmware: 2.1.03
Please if you have any ideas I would love to hear them otherwise it is rtma time.
|
|
|
Post by changlinn on Mar 2, 2007 7:00:56 GMT 7
Heh I think the array may have failed due to all the users and folders and other stuffing around I was doing during the build. When it rebuilt I didn't do anything and now everything works. ;D
|
|