|
Post by greybard on Feb 14, 2007 22:58:22 GMT 7
I was editing and haven't used VI in forever.
Must have hit a key somewhere and screwed up the getform.
Can anyone post one so I can figure out what I blew up?
Thanks!
|
|
|
Post by RazzleUltra on Feb 14, 2007 23:03:06 GMT 7
This is mine AFTER I modded it (cheers Omega!) to correctly display module property pages (1.00.07).
|
|
|
Post by greybard on Feb 14, 2007 23:25:54 GMT 7
Thank you, Thank you!
I am now up and running!
Info is showing that one of my fans is running at 0, I am going to assume that means there is a place in my 5200 for an additional fan that isn't installed at the factory...
Is there and what size (80mm perhaps) does it take?
Thanks all!
|
|
|
Post by omega on Feb 15, 2007 0:12:43 GMT 7
Hi greybard, 1) There is only one FAN so the speed for FAN 1 is intentionally zero But please don't ask me why I have it included in the overview.... 2) I don't start an introduction to vi here, but only one recipe for emergency cases: a) First hit the escape key (ESCAPE) in order tocome back to the command mode. It is always save to hit the escape key (even multiple times)... b) Now that you are in command mode and if you want to leave vi without saving anything to disk, just enter " :q!" (without the double quotes). The colon starts a file command, the "q" tells vi that we want to quit and the "!" exclamation mark tells vi that even though the file has been modified we want to quit without writing it. That's all.... Andreas
|
|