|
|
Post by trinode on Dec 8, 2007 6:58:00 GMT 7
Install as a module, the thecus will say installation failed (don't worry, it worked) disable the print server enable the print server now the disks should spin down (if they normally would without the print server) www.siteblade.com/PrintSpinDown.zipTested with Printserver 1.0.02 on firmware 2.0.04, to undo the fix remove and reinstall the PrinterServer module. - Anthony |
|
|
|
Post by N2100Owner on Dec 8, 2007 23:26:14 GMT 7
Did you just fix the "RootCertDuration 0"? or is there some other fix you did?
|
|
|
|
Post by trinode on Dec 9, 2007 5:17:46 GMT 7
yeah, it's the rootcertduration setting, it overwrites the cupsd.conf when installed (mostly did it for those not comfortable with ssh / vi)
I wrapped it as a module installer and got it to signal install failed after it overwrote the file, as it didn't need a module setting page or anything.
|
|
|
|
Post by N2100Owner on Dec 9, 2007 9:52:32 GMT 7
Perhaps you should also inform Thecus and tell them to update the module.
|
|
|
|
Post by trinode on Dec 9, 2007 17:36:27 GMT 7
This is a result of thecus ignoring my threads on their semi-official forum on hexus (it is monitored by thecus), I'll give it a few more days then e-mail them, do you have a better contact name than support@... ?
|
|
|
|
Post by getmythe on Dec 9, 2007 17:57:05 GMT 7
... or you could patch the module yourself  |
|
|
|
Post by trinode on Dec 9, 2007 18:04:19 GMT 7
I've no idea how to decrypt the 4100+ official modules (.app), they're not the standard tar.gz's renamed, any pointers?
I've opened up a support ticket on their site now.
|
|
adam
New Member
Posts: 22 
|
Post by adam on Dec 10, 2007 5:19:07 GMT 7
So, what's the manual edit fix via SSH for those of us who are brave enough?  |
|
|
|
Post by trinode on Dec 10, 2007 5:21:28 GMT 7
Add the line:-
RootCertDuration 0
to /raid/module/PrinterServer/system/etc/cups/cupsd.conf
then disable and re-enable the PrinterServer module
|
|
|
|
Post by getmythe on Dec 16, 2007 6:14:57 GMT 7
The modules may be decrypted the same way as the firmware, only the key is different (AppModule).
|
|
|
|
Post by trinode on Dec 16, 2007 19:01:37 GMT 7
I assume
1) decrypt
2) untar
3) make change
4) tar
5) encrypt
what is the command incl key for 1 & 5?
|
|
|
|
Post by getmythe on Dec 16, 2007 22:25:46 GMT 7
to be executed on the thecus itself
1) des -k AppModule -D module.app module.mod
2) tar zxf module.mod
3) your problem ;D
4) tar zcf module.mod ./module
5) not necessary
replace 'module' with actual name in points 1) to 4)
|
|
