|
Post by bobwadd on Jan 1, 2012 21:33:45 GMT 7
Hi, I am running a N5200PRO with firmware 2.00.18.4 with no issues until recently. I had a need to change my "Scheduled Power On/Off" settings. No problem, new setting work fine. But, the old settings are also still active. I have tried setting it back to the old setting disabling the power manager and then reactivating it with the new setting and the problem persists.
Any help would be greatly appreciated, Bob
|
|
|
Post by bobwadd on Feb 9, 2012 7:12:46 GMT 7
Anyone? What if I reflash the firmware? Will that reset the power management settings? And will my RAID/Folders be preserved? Thanks
|
|
|
Post by bobwadd on Jul 20, 2013 9:02:08 GMT 7
Well I have recently acquired another NAS system and will now be using the N5200 as a backup. So far I have applied the default setting through the web interface, upgraded the firmware and once again applied the default settings with no luck. Once again I am asking for help in removing the old power management setting as the original issue is still happening. I can add new on and off times or turn off power management all together but I can not get rid of the old settings.
Ok, I just added a VGA connector to my older unit so I could access the interface. Can anyone help me now???
|
|