Post by simonj on May 31, 2009 20:20:21 GMT 7
I have just dusted down my n299 from the cupboard as I need some more backup space and thought I would try again with this box as I had put it in the cupboard about a year ago, in disgust with its noise output and power consumption (no sleep etc.).
However, when I plugged it in and turned on the power supply nothing...!
The box is running it's original firmware and had two WD 500 disks in it. It was running the last time I plugged it in.
I have tried the little reset button on back but it just fails to light up or beep or anything. There is a light on the power adapter though.
Any ideas?
Is the little cell on the motherboard required to have power to boot??
Thanks,
Simon
However, when I plugged it in and turned on the power supply nothing...!
The box is running it's original firmware and had two WD 500 disks in it. It was running the last time I plugged it in.
I have tried the little reset button on back but it just fails to light up or beep or anything. There is a light on the power adapter though.
Any ideas?
Is the little cell on the motherboard required to have power to boot??
Thanks,
Simon