Upgrade to 2.00.08 and modules

[oagers]

Have upgraded to 2.00.08 but i ran the command "mv /raid/data/module /raid/data/module.save" and now my modules wold not show up in the GUI. Is it just renaming the /module.save folder back to /module. How to? I cant connect via ssh, please help.

[peterfu]

hmmm, as access via ssh is also a module of course there is no possibility to connect now, cause You have removed the modules with the command.
I assume You have rebooted Your device after You have ran the command, so module management is available. Then the best would be to reinstall all the modules. If YOu realy want to resuse yourold installations, then You have to do a new installation of the SYSUSER and SSHD module to get ssh access to the N5200 again, the You may ran the command:
mv /raid/data/module.save /raid/data/module
But I would recommend to do a brand new installations of all the modules and eventually move from the modules.save folders some configuration files only - if needed.
br
Peter

[oagers]

Hi Peter,
That would be an easy solution, just reinstall the module. After the reinstallation the module, it will not show in the GUI, and the module is not installed.
Is it possible to connect to the thecus via a serial cable? That will neither work since all my modules are disabled.
Any other solutions?

[peterfu]

hmm, thats strange - usually after deleting the /raid/data/module directory (what You have done with the mv command) and rebooting the whole module subsystem is rebuild from scratch.
may be a dumb question, but:
Are You using the .mod files or the .zip files of the modules ?

To clean it up again, You can use the RENMOD batch and apply that as a firmware upgrade - and do a reboot afterwards.
br
Peter

[oagers]

Hi Peter,
Thanks for the tips, i was yousing .zip rather than the .mod file.
Have installed the .mod files and enabled the module. Everything works fine.

Many thanks Peter!

[peterfu]

You're welcome - thats a common PEBKAC (Problem exists between Keyboard and chair) ;D
br
Peter