TWONKYMEDIA Module Help

[cyberwolf42]

This may sound stupid, but I just installed and enabled the TwonkyMedia Module, and rebooted by N5200.

How do I configure it and/or set it up? There doesn't seem to be a way to do this from the Module Management page.

The link under "Name" reads TWONKYMEDIA and yields this link (http://192.168.1.25/adm/getform.html?Module=TWONKYMEDIA) which loads a single page that says "no name given".

The link under "Description" reads "TwonkyMedia UPnP Media Server" and yields this link (http://192.168.1.25/adm/getform.html?name=module_desp&module=TWONKYMEDIA)
which just gives me information. There's only one link on that page which reads: (http://onbeat.dk/thecus/index.php/N5200_Module:_TWONKYMEDIA)

SUGGESTIONS ANYONE? I looked in the wiki and it had no information about this.

Thanks!

[spiken]

Do you tried http://youThecusIp:9000 ?

[cyberwolf42]

Spiken -- THANK YOU! That's it. For some reason, I either didn't see it anywhere in the module docs on the wiki, or it is just plain not there. I was looking for something like this on the Twonkymedia site but couldn't find it.

Thanks again -- you rock! Can't wait to play around with it now!

[peterfu]

It is mentioned in the installation guide

http://your-ip:port/configpage/index.htm
where "your-ip" is the IP address of the device where the MediaServer is running and port is the port number of the MediaServer’s HTTP server (9000 by default).

Everything else is explained in the built in help.
br
Peter