Post by bens on May 3, 2010 16:31:44 GMT 7
I had a RAID5 array (disks 1-7) defined and recently got an error on disk 1. Sure enough the array is in degraded state with disks 2-7 defined, however disk1 shows up "OK".
Assuming it was just a transient hardware error, is it a matter of just adding disk1 back as a hot spare?
I get the message that "All active services will be stopped when operation is in progress" does this mean the iSCSI and SMB servers will stop?
Assuming it was just a transient hardware error, is it a matter of just adding disk1 back as a hot spare?
I get the message that "All active services will be stopped when operation is in progress" does this mean the iSCSI and SMB servers will stop?