punga
New Member
Posts: 1
|
N299
Jan 27, 2008 5:33:47 GMT 7
Post by punga on Jan 27, 2008 5:33:47 GMT 7
Have had my N299 up and running, after a reboot from PC I could not reconnect, could not map the N299, could not access it through the Set Up Wizard but using the IP address NOT THE DEFAULT I can reach the login page only to find using admin/admin (I have not changed the password) I receive a message saying I am not permitted to access this system. Q. how can I reset the unit to manufacturer's settings. Removing the button battery with the power disconnected did not help.
Any suggestions Please!!
|
|
|
N299
Feb 13, 2008 13:59:51 GMT 7
Post by atrix415 on Feb 13, 2008 13:59:51 GMT 7
I am unsure about the N299 but on the N2100 near the ethernet ports there is a hole with a black button you can push on the back of the device. Try to hold on it off for like 20-30 seconds or on for 20-30 (Don't remember which sequence) then see if it gotten reset.
|
|